Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Высокие технологии Fuel Injection system
просмотров - 257

Using and ohmmeter, measure the resistance across tne terminals of the injector

A On Non-VVT-i engines, the diagnostic plug is located adjacent to the left-hand front suspension turret

illustration).If you don't have an automotivestethoscope you can use a long screwdriver; just place the tip of the screwdriver against the injector body and press your ear against the handle.

8 With the engine OFF and the fuel injector electrical connectors disconnected, measure the resistance of each injector (see illustration).Each injector shouldmeasureabout 13.4 to 14.2 ohms. If not, the injector is probably faulty.

9 The remainder of the system checks should be left to a dealer service department or other suitably-equipped repairer, as there is a chance that the control unit may be damaged if not performed properly.

10 All models are equipped with a sophisticated self-diagnosis system, whereby any faults are stored as codes within the engine management ECM. By connecting suitable hand-held diagnostic equipment to the relevant connector (see illustrations), the stored code can be retrieved, and the fault identified. See your dealer or repair specialist.

- component testing and renewal

Warning: Petrol is extremely flammable, so take extra precautions when you work on any part of the fuel system. Don't smoke

or allow open flames or bare light bulbs near the work area, and don't work in a

11.10b On VVT-i engines, the 16-pin diagnostic plug is located under the driver's side of the facia

4A•8 Fuel and exhaust systems


Читайте также


  • - Fuel Injection system

    - testing and adjustment 1 Check the earth wire connections for tightness. Check all wiring and electrical connectors that are related to the system. Loose electrical connectors and poor earths can cause many problems that resemble more serious malfunctions. 2 Check to see that the battery is fully-charged, as the control unit and sensors depend on an accurate supply voltage in order to properly meter the fuel. 3 Check the air filter element - a dirty or partially-blocked... [читать подробенее]


  • - Fuel injection system

    - depressurisation 1 Before servicing any fuel system component, you must relieve the fuel pressure to minimise the risk of fire or personal injury. 2 Remove the fuel filler cap - this will relieve any pressure built-up in the tank. 3 Remove the rear seat from the passenger cabin, then prise up the fuel pump/sender unit access cover (see illustration 3.4). 4 Remove the fuel pump connector (see illustration 3.5a). 5 Start the engine and wait for the engine to stall, then... [читать подробенее]