Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Высокие технологии Position the No 1 cylinder camshaft lobes away from the followers
просмотров - 130

Intake camshaft bearing cap bolt tightening sequence - 1.6 litre

Use the installation marks, NOT the timing marks

Exhaust camshaft bearing cap bolt tightening sequence - 1.6 litre

Apply sealant to the shaded areas of the exhaust camshaft bearing cap

2A•16 Engine in-car repair procedures

  85 Align the camshaft sprocket timing
  marks (see illustration 3.7b), then rotate
  the crankshaft 90° clockwise, back to TDC
  position (with the crankshaft key upright in the
  12 o'clock position).  
  86 Refit the timing chain as described in
  Section 6.  
  11 Cylinder head-  
  removal and refitting  
10.79 Lift the followers from position Note:The engine must be completely cool
  before beginning this procedure.

in numerical order with the arrows pointing toward the timing belt end of the engine.

70 Following the recommended sequence

(see illustration),tighten the bearing capbolts in 1/4-turn increments to the torque listed in this Chapter's Specifications.

71 Remove the service bolt from the intake camshaft gear.

72 Install the timing belt sprocket on the exhaust camshaft and tighten the bolt to the torque listed in this Chapter's Specifications. Prevent the camshaft from turning by holding it with a spanner on the hexagonal section.

73 Install the timing belt (see Section 5).

74 The remainder of refitting is the reverse of the removal procedure.