Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Строительство ELECTRICAL SYSTEM 16-23
просмотров - 278

NOTE

The electrolyte contains sulfuric acid. Be careful not to have it touch your skin or eyes. If touched, wash it off with liberal amount of water. Get medical attention if severe.

Interchange

The sealed battery can fully display its performance only when combined with a proper vehicle elec­tric system. Therefore, replace the sealed battery only on a motorcycle which was originally equipped with the sealed battery.

Be careful, if a sealed battery is installed on a motorcycle which had an ordinary battery as original equipment, the sealed battery’s life will be shortened. Charging Condition Inspection

Battery charging condition can be checked by measuring battery terminal voltage.

• Remove the seat (see Seat Removal in the Frame chap­ter).

Disconnect the battery terminals.

CAUTION Be sure to disconnect the negative terminal first.

• Measure the battery terminal voltage.

О Measure with a digital voltmeter [A] which can be read one decimal place voltage.

If the reading is below the specified, refreshing charge is required.

Battery Terminal Voltage Standard: 12.8 V or more


Читайте также


  • - Power Supply Electrical Systems and Networks

    Прочитайте и переведите текст. I am a second-year student of the Bratsk State University. My future speciality is power supply to industrial enterprises, cities and rural regions. I am also trained to work in the field of electrical systems and networks. I am sure that my speciality is of great importance because power engineering is a key industry. The problems it deals with concern the efficient generation and distribution of electrical power. It is one of the... [читать подробенее]


  • - Electrical System

    II. Read about the lubrication system and describe it using the diagram. The lubrication system delivers oil to the moving parts of the engine. As the oil circulates through passages in the engine it spreads a film on the parts. Lubrication reduces friction and so minimizes engine wear. The oil also helps to cool the engine. Oil is stored in a pan under the engine. A pump circulates oil from the pan through a filter and then through lines to the engine. This filter prevents... [читать подробенее]


  • - ELECTRICAL SYSTEM Specifications

    Exploded View ELECTRICAL SYSTEM 16-9 Exploded View ELECTRICAL SYSTEM No. Fastener Torque Remarks N-m kgf-m ft-lb Side Stand Switch Mounting Screw 3.9 0.4 35 inlb L Ignition Switch Rear Brake Light Switch Front Brake Light Switch Starter Lockout Switch City Light L: Apply a non-permanent locking agent.... [читать подробенее]


  • - ELECTRICAL SYSTEM 16-65 Fuses

    Junction Box Internal Circuit Junction Box ELECTRICAL SYSTEM NOTE Diode Circuit Inspection Relay Circuit Inspection (with the battery connected)   Battery Connec­tion (+) (–) Te s t e r Connection Te s t e r Reading (&... [читать подробенее]


  • - ELECTRICAL SYSTEM 16-27 Charging System

    NOTE ОTo keep the loss of engine oil to a minimum, set the motorcycle vertically. • Remove the alternator cover (see Alternator Rotor and Starter Clutch Removal). • Remove the screws [A] and the holding plate [B] for the stator wiring. • Unscrew the Allen bolts [C] and remove the stator [D]. Remove the grommet for the crankshaft sensor lead. Alternator Stator Installation • Apply silicone sealant [A] around the circumference of the wiring grommets... [читать подробенее]


  • - ELECTRICAL SYSTEM 16-23

    NOTE The electrolyte contains sulfuric acid. Be careful not to have it touch your skin or eyes. If touched, wash it off with liberal amount of water. Get medical attention if severe. Interchange The sealed battery can fully display its performance only when combined with a proper vehicle elec­tric system. Therefore, replace the sealed battery only on a motorcycle which was originally equipped with the sealed battery. Be careful, if a sealed battery is installed on a... [читать подробенее]


  • - Electrical System

    NOTE OTurn the stem nut 1/8 turn at a time maximum. Torque -Steering Stem Nut: 4.9 N-m (0.50 kgf-m, 43 in-lb, for reference) • Tighten the steering stem head nut [B] and fork lower clamp bolts [A]. Torque - Steering Stem Head Nut: 39 N-m (4.0 kgf-m, 29 ft-lb) Fork Lower Clamp Bolts: 23 N-m (2.3 kgf-m, 17 ft-lb) • Check the steering again. + •If the steering is still too tight or too loose, repeat the ad­ justment. Steering Stem Bearing Lubrication • Remove the... [читать подробенее]


  • - ELECTRICAL SYSTEM

    NOTE CAUTION Quick Charge Battery     Refreshing Charge и WARNING This battery is sealed type. Never remove seal cap [B] even at charging. Never add water. Charge with current and time as stated below. • Disconnect the battery terminals (see Charging Condition Inspection). • Remove the battery [A]. • Do refresh-charge by following method according to the battery terminal voltage. Terminal Voltage:... [читать подробенее]


  • - ELECTRICAL SYSTEM

    NOTE Electric Starter System ELECTRICAL SYSTEM 16-47 Armature Inspection • Using the × 1 Qhand tester range, measure the resis­tance between any two commutator segments [A]. • If there is a high resistance or no reading (°°) between any two segments, a winding is open and the starter motor must be replaced. • Using the highest hand tester range, measure the resis­tance between the segments and the shaft [B]. • If there is... [читать подробенее]