Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Строительство Handlebar
просмотров - 103

Handlebar Removal

• Remove:

Plugs

Clutch Lever (see Clutch Lever Removal in the Clutch

chapter)

Right and Left Handlebar Switch Housing

Throttle Grip

Front Brake Master Cylinder (see Front Brake Master

Cylinder Removal in the Brakes chapter)

• Unscrew the handlebar mounting bolts [A] and remove the handlebar [B] and clamp [C].

Handlebar Installation

• Install the handlebar clamps so that the arrow [A] on the clamp points to the front.

• Set the handlebar to match its punched mark [B] to the lower mating face [C] of the clamp rear part.

• Tighten the front clamp bolts first, and then the rear clamp bolts. There will be a gap [A] at the rear part of the clamp after tightening.

Torque - Handlebar Clamp Bolts: 25 N-m (2.5 kgf-m, 18 ft-lb)

• The front half of the right and left switch housings [A] has a small projection [B]. Fit the projection into the small hole [C] in the handlebar.

• Install the handlebar switch housing.

• Install:

Front Master Cylinder (see Front Brake Master Cylinder

Installation in the Brakes chapter)

Clutch Lever (see Clutch Lever Installation in the Clutch

chapter)


Читайте также


  • - HANDLEBAR INSTALLATION

    Do not attempt to straighten a bent handlebar as this may dangerously weaken the handlebar. HANDLEBAR INSPECTION HANDLEBAR REMOVAL HANDLEBAR CHAS K-2 HANDLEBAR CHAS 1. Remove: • Grip (Left) ************************************************************ Removal Steps Remove the left grip end Blow with compressed air between the handlebar and adhesive side of the grip to remove. ... [читать подробенее]


  • - HANDLEBAR CHAS

    K-1 FRONT FORK CHAS FRONT FORK INSTALLATION Reverse the “REMOVAL” procedure. Note the following points: 1. Install: • Front fork Ø • Temporarily tighten the pinch bolts. HANDLEBAR NOTE: Pull up the inner tube until tie end flushes the top of the under bracket Ø, then temporarily tighten the bolt (under bracket lower) Ø. 2. Tighten: 1• Pinch bolts (under bracket upper / lower) Ø 23 Nm (2.3... [читать подробенее]


  • - Handlebar

    Handlebar Removal • Remove: Plugs Clutch Lever (see Clutch Lever Removal in the Clutch chapter) Right and Left Handlebar Switch Housing Throttle Grip Front Brake Master Cylinder (see Front Brake Master Cylinder Removal in the Brakes chapter) • Unscrew the handlebar mounting bolts [A] and remove the handlebar [B] and clamp [C]. Handlebar Installation • Install the handlebar clamps so that the arrow [A] on the clamp points to the front. • Set... [читать подробенее]


  • - Handlebar

    Handlebar Removal • Remove: Plugs Clutch Lever (see Clutch Lever Removal in the Clutch chapter) Right and Left Handlebar Switch Housing Throttle Grip Front Brake Master Cylinder (see Front Brake Master Cylinder Removal in the Brakes chapter) • Unscrew the handlebar mounting bolts [A] and remove the handlebar [B] and clamp [C]. Handlebar Installation • Install the handlebar clamps so that the arrow [A] on the clamp points to the front. • Set... [читать подробенее]