Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Строительство Immediately wipe up any brake fluid that spills.
просмотров - 188

Master Cylinder

BRAKES 12-17

Front Master Cylinder Removal

CAUTION

• Disconnect the front brake switch connectors [A].

• Remove the banjo bolt [B] to disconnect the upper brake hose end from the master cylinder [C]. There is a flat washer on each side of the hose fitting.

• Remove the clamp bolts [D] and take off the master cylin­der as an assembly with the reservoir, brake lever, and brake switch installed.

Front Master Cylinder Installation

• Apply grease to the extreme end of the clamp bolts.

• Install the master cylinder clamp so that the upper mating surface [A] of the clamp is aligned with the punch mark [B] on the handlebar.

• Tighten the upper clamp bolt first, and then the lower clamp bolt. There will be a gap at the lower part of the clamp after tightening.

Torque - Master Cylinder Clamp Bolts: 8.8 N·m (0.9 kgf·m, 78 in·lb)

• Use a new flat washer on each side of the brake hose fitting.

• Tighten the banjo bolt.

Torque - Brake Hose Banjo Bolt: 34 N·m (3.5 kgf·m, 25 ft·lb)

• Bleed the brake line after master cylinder installation (see Bleeding the Brake Line).

• Check the brake for weak braking power, brake drag, and fluid leakage.

H


Читайте также


  • - Immediately wipe up any brake fluid that spills.

    Master Cylinder BRAKES Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc. The brake will not function on the first application of the lever if this is not done. WARNING Rear Master Cylinder Removal • Remove the right side cover. Remove the muffler cover bolts [A] and muffler cover [B]. • Pull out the cotter pin [A] from the pin [B] fixing the pin so... [читать подробенее]


  • - Immediately wipe up any brake fluid that spills.

    Master Cylinder BRAKES 12-17 Front Master Cylinder Removal CAUTION • Disconnect the front brake switch connectors [A]. • Remove the banjo bolt [B] to disconnect the upper brake hose end from the master cylinder [C]. There is a flat washer on each side of the hose fitting. • Remove the clamp bolts [D] and take off the master cylin­der as an assembly with the reservoir, brake lever, and brake switch installed. Front Master Cylinder... [читать подробенее]