Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Строительство Immediately wipe up any brake fluid that spills.
просмотров - 175

Master Cylinder

BRAKES

Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc. The brake will not function on the first application of the lever if this is not done.

WARNING

Rear Master Cylinder Removal • Remove the right side cover. Remove the muffler cover bolts [A] and muffler cover [B].

• Pull out the cotter pin [A] from the pin [B] fixing the pin so that it does not turn, and remove the pin.

CAUTION

• Remove the reservoir mounting bolt [A].

• Remove the brake hose banjo bolt [B].

• Remove the rear master cylinder mounting bolts [C] and pull up the master cylinder with the reservoir tank.

Rear Master Cylinder Installation

• Install the removed parts in order to the reverse of re­moval.

• Install the new cotter pin and bend it the end of itenoughly after connecting the connecting rad and pin.

Torque - Brake Hose Banjo Bolt: 34 N·m (3.5 kgf·m, 25 ft·lb) Rear Master Cylinder Mounting Bolts: 25 N·m (2.5 kgf·m, 188 in·lb)

• Bleed the brake line after master cylinder installation (see Bleeding the Brake Line).

И


Читайте также


  • - Immediately wipe up any brake fluid that spills.

    Master Cylinder BRAKES Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc. The brake will not function on the first application of the lever if this is not done. WARNING Rear Master Cylinder Removal • Remove the right side cover. Remove the muffler cover bolts [A] and muffler cover [B]. • Pull out the cotter pin [A] from the pin [B] fixing the pin so... [читать подробенее]


  • - Immediately wipe up any brake fluid that spills.

    Master Cylinder BRAKES 12-17 Front Master Cylinder Removal CAUTION • Disconnect the front brake switch connectors [A]. • Remove the banjo bolt [B] to disconnect the upper brake hose end from the master cylinder [C]. There is a flat washer on each side of the hose fitting. • Remove the clamp bolts [D] and take off the master cylin­der as an assembly with the reservoir, brake lever, and brake switch installed. Front Master Cylinder... [читать подробенее]