Категории
Образование
CHECKING THE REAR SHOCK ABSORBER просмотров - 539
Support the scooter so that it cannot fall over
CHECKING THE SWING-ARM
1. Place the scooter on a flat surface
2. Check:
• That it works properly
Grasp the end of the swing-arm and gently rock the swing-arm assembly back and forth
If it does not do so smoothly, repair it
See section on REAR SHOCK ABSORBER AND SWINGARM in Chapter 7
************************************************************
6. Install:
• Upper front panel
CHECKING THE FRONT FORK
sWARNING:
1. Stand the scooter on a level surface 2.Check:
• Inner tube
If there are any scratches or damage, replace it
• Oil seal
Replace if there is excessive leakage of oil
Hold the scooter upright and apply the front brake
3. Check:
• That it works properly
Push down hard on the handlebars several times If it does not work smoothly, repair it
See FRONT FORK in Chapter 7
1
b a
1. Check:
• Rear shock absorber mount Tighten up where necessary Bolt (upper)
32 Nm (3,2 m•kg)
Screw (lower)
35 Nm (3,5 m•kg)
See section on REAR SHOCK ABSORBER AND SWINGARM in Chapter 7
Читайте также
Support the scooter so that it cannot fall over CHECKING THE SWING-ARM 1. Place the scooter on a flat surface 2. Check: • That it works properly Grasp the end of the swing-arm and gently rock the swing-arm assembly back and forth If it does not do so smoothly, repair it See section on REAR SHOCK ABSORBER AND SWINGARM in Chapter 7 ************************************************************ 6. Install: • Upper front panel CHECKING THE FRONT FORK ... [читать подробенее]