Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Образование CHK ADJ
просмотров - 183

Before removing the spark plug, use compressed air to blow away any dirt accumulating in the spark plug wells to prevent it from falling into the cylinder.

SPARK PLUG INSPECTION

After adjusting, turn the handlebar to the right and to the left to ensure that this does not cause the engine idling speed to change.

1. Remove

• spark plug cap

• spark plug

CAUTION:

2. Check

• Spark plug type

If incorrect, replace

Standard spark plug: CR8E (NGK)

3. Inspect:

• The electrode Ø

If worn or damaged, replace it

• The insulator Ø

If colour is abnormal, replace it

Normal colour is a medium-to-light tan colour

4. Clean:

• Spark plug

(with spark plug cleaner or wire brush)

5. Measure:

• Spark plug gap Ø

(with a wire gauge)

If not as specified, correct it

SPARK PLUG INSPECTION/ IGNITION TIMING CHECK


Читайте также


  • - CHK ADJ

    Before removing the spark plug, use compressed air to blow away any dirt accumulating in the spark plug wells to prevent it from falling into the cylinder. SPARK PLUG INSPECTION After adjusting, turn the handlebar to the right and to the left to ensure that this does not cause the engine idling speed to change. 1. Remove • spark plug cap • spark plug CAUTION: 2. Check • Spark plug type If incorrect, replace Standard spark plug: CR8E (NGK) 3.... [читать подробенее]


  • - CHK ADJ

    D-9 CHK ADJ CHECKING ENGINE OIL Before removing the spark plug, use compressed air to blow away any dirt accumulated in the spark plug well, to prevent it from falling into the cham- ber. 6. Attach • Compression gauge Compression gauge: 90890: 03081 7. Measure: • Compression pressure If it exceeds the maximum pressure allowed, then inspect the cylinder head, valve surfaces and pis- ton crown for carbon deposits. If it is below the minimum pressure,... [читать подробенее]


  • - CHK ADJ

    PERIODIC CHECKS AND MAINTENANCE D-2 CHK ADJ CABLE ROUTING SPEC CABLE ROUTING SPEC C-12 Ø Right handlebar switch Ø Left handlebar switch Ø Front brake switch Rear brake switch Ø Throttle cable Rear brake hose Ø Front brake hose       CHK ADJ PERIODIC CHECKS AND MAINTENANCE     No.     ITEM     ... [читать подробенее]


  • - CHK ADJ

    TRANSMISSION OIL REPLACEMENT D-10 CHK ADJ ENGINE PRESSURE INSPECTION CHECKING ENGINE OIL 1. Stand the scooter on a level surface b• Drain plug • Compression spring • Oil-strainerØ • O-ring • Drain the crankcase of its oil NOTE: Make sure the scooter is upright when inspecting the oil level 2. Start the engine and let it warm up for a few minu- tes 3. Turn off the engine 4. Check: 3 • Engine oil level 1 2 1Oil... [читать подробенее]


  • - CHK ADJ

    E-1 CHK ADJ Do not over-tighten • Check the steering head for looseness or binding by turning it all the way in both directions. If it binds, remove the steering stem assembly and check the steering bearings See STEERING HEAD in Chapter 7 • Install the rubber washer • Install the rubber nut (centre) Ø • Finger-tighten the ring-nut (centre), then align the slots of both ring nuts. If necessary, hold the ring-nut (lower) Ø and tighten the... [читать подробенее]


  • - CHK ADJ

    D-11 CHK ADJ Clean oil splashes from wheel TRANSMISSION OIL REPLACEMENT / CHECKING THE EXHAUST SYSTEM/CLEANING THE AIR FILTER CLEANING THE AIR FILTER/ CLEANING THE CRANKCASE FILTER 7. Install: • Oil filter cap Ø • O-ring a8. Start the engine and warm it up for several minutes 1 to check for leakage of oil 3. Inspect: • Air filter element If damaged, replace it 4. Clean • Air filter element Ø Use compressed... [читать подробенее]


  • - CHK ADJ

    TYRE PRESSURE E-2 CHK ADJ TYRE PRESSURE Always adjust each rear shock absorber pre-load to the same setting. Uneven adjustment can cause poor handling and loss of stability Support the scooter so that it cannot fall over ADJUSTING THE REAR SHOCK ABSORBER sWARNING: 1. Adjust: • Spring pre-load Turn the adjuster ring Ø to direction (a) or (b) NOTE: Use the special wrench included in the owner’s tool kit to adjust the spring... [читать подробенее]


  • - CHK ADJ

    D-6 CHK ADJ VALVE CLEARANCE ADJUSTMENT CHK ADJ SEAT AND PANELS D-5 CHK ADJ SEAT AND PANELS   Order   Job name/part name   Quantity   Remarks       Removal of handle cover,     Remove the parts in order   meter assembly and footrest     Windshield     Front cover     ... [читать подробенее]


  • - CHK ADJ

    D-7 CHK ADJ THROTTLE CABLE ADJUSTMENT/ SPARK PLUG INSPECTION 3. Check: • Engine idling speed If not as specified —( adjust Engine idling speed: 1,600 ~ 1,800 r/min • Loosen the lock-nut Ø on the throttle cable • Turn the adjuster Ø in or out until specified free play is obtained Turning in —( free play is increased Turning out —( free play is decreased 4. Adjust • Engine idling speed ... [читать подробенее]


  • - CHK ADJ

    SEAT AND PANELS D-4 CHK ADJ SEAT AND PANELS FUEL TANK CHK ADJ SEAT AND PANELS D-3 CHK ADJ SEAT AND PANELS SEAT AND PANELS SEAT AND PANELS   Order   Job name/part name   Quantity   Remarks   Removal of fuel tank   Remove the parts in order Seat lock bridge Disconnect gauge Gasoline exit hose ... [читать подробенее]