Категории
Образование
CRANKCASE AND CRANKSHAFT ENG просмотров - 522
G-7
TRANSMISSION ENG
|
TRANSMISSION CRANKCASE AND CRANKSHAFT
Order | Job name/part name | Quantity | Remarks |
Transmission removal | Refer to REAR WHEEL/REAR BRAKE | ||
section in Chapter 7. | |||
Crankcase cover (left) | Refer to V-BELT, CLUTCH | ||
SECONDARY / PRIMARY SHEAP | |||
section | |||
Drain the transmission oil | Refer to TRANSMISSION OIL | ||
REPLACEMENT section in Chapter 3. | |||
Transmission case cover | |||
Gasket (transmission case cover) | |||
Dowel pin | |||
Primary drive gear | |||
Plain washer | |||
Secondary axle pinion | |||
Intermediate axle | |||
Secondary axis (wheel) | |||
Washer |
Читайте также
G-7 TRANSMISSION ENG Order Job name/part name Quantity Remarks Crankcase and Crankshaft removal Engine Removal Cylinder Head Cylinder, piston V-Belt, clutch, secondary/primary sheaf A.C. magneto, starter clutch Oil pump Rear wheel Starter motor Remove parts in order Refer to ENGINE REMOVAL section Refer to CYLINDER HEAD section Refer to... [читать подробенее]
G-8 CRANKCASE AND CRANKSHAFT ENG CRANKCASE AND CRANKSHAFT CRANKSHAFT REMOVAL 1. Remove: • Crankshaft assembly • Timing chain Ø NOTE: Before removing the crankshaft assembly, remove the timing chain from the crankshaft sprocket. If the timing chain hooks to the crankshaft sprocket, the crankshaft cannot be removed. CRANKSHAFT INSPECTION 1. Measure: • Crankshaft run-out Out of specification —( replace crankshaft and/or bearing. ... [читать подробенее]