Open Library - открытая библиотека учебной информации

Открытая библиотека для школьников и студентов. Лекции, конспекты и учебные материалы по всем научным направлениям.

Категории

Образование To avoid damage to the bearing surfaces, do not use compressed air to dry the bearings.
просмотров - 175

LOCK WASHERS, PLATES AND COTTER PINS

GASKETS, OIL SEALS AND O-RINGS

1. Replace all gaskets, seals, and O-rings when over- hauling the engine. All gasket surfaces, oil seal lips and O-rings must be cleaned

2. Properly oil all mating parts and bearings during re- assembly. Apply grease to the oil seal lips.

1. Replace all lock washers, plates Ø and cotter pins after removal. Bend lock tabs along the bolt or nut flats after the bolt or nut has been tightened as spe- cified.

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the manufactu- rer’s marks or numbers are visible. When installing oil seals apply a thin coating of lightweight lithium grea- se to the seal lips.

Ø oil seal

CAUTION:

Ø Bearings

CIRCLIPS

1. Examine all of the circlips before re-assembly. Always replace circlips after removing them. Repla- ce distorted circlips. When installing a new circlip

Ø, check that the edged corner Ø is positioned

opposite the direction of the thrust Ø it receives. See the section drawing.

Shaft